Canon MP492 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MP492 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MP492. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.

FAQ