Model-specific reset guide
Canon MG6800 Ink Absorber Full Reset
The waste ink system in Canon MG6800 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
The waste ink counter inside Canon MG6800
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG6800. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG6800
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG6800
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG6800 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG6800 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon MG6800 directly to the computer and try another data-capable USB cable or port.
Canon MG6800 reset FAQ
Does Canon MG6800 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
How many times should I press Stop/Reset?
For Canon MG6800, use 6 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon MG6800
Ready to reset Canon MG6800? Verify the power light, USB connection and service-mode state before continuing.