Model-specific reset guide
Canon MG6730 Ink Absorber Full Reset
If Canon MG6730 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
What the Canon MG6730 service message means
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon MG6730 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon MG6730. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG6730
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG6730
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG6730 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG6730 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MG6730 reset FAQ
Does Canon MG6730 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
How many times should I press Stop/Reset?
For Canon MG6730, use 6 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon MG6730
Complete the Canon MG6730 absorber counter reset in a few carefully prepared steps.