Canon MB2700 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MB2700 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MB2700. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions