Model-specific reset guide
Canon G3111 Ink Absorber Full Reset
When Canon G3111 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
Before resetting Canon G3111
Cleaning operations send unused ink into absorber pads inside the printer. Canon G3111 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon G3111. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G3111
- Turn the printer off.
- Press and hold Stop/Reset.
- While holding Stop/Reset, press and hold Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G3111
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G3111 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G3111 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon G3111 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon G3111 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon G3111 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
How many times should I press Stop/Reset?
For Canon G3111, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon G3111
Complete the Canon G3111 absorber counter reset in a few carefully prepared steps.