Epson XP-400 Waste Ink Counter Reset

Epson XP-400 Waste Ink Counter Reset

When the Epson XP-400 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson XP-400 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson XP-400 Waste Ink Counter

Most Epson XP-400 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson XP-400 Waste Counter Reset

  1. Schritt 1: Connect Epson XP-400 to a Windows computer with a stable Internet connection using a USB cable.
  2. Schritt 2: Run Wic Reset Connect as Administrator and confirm Epson XP-400 is detected.
  3. Schritt 3: Paste the reset key, click Reset, and after completion power-cycle Epson XP-400.
Buy Reset Key ⬇️ Download Wic Reset Connect Anweisungen

Most Epson XP-400 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson XP-400 – Waste Ink Counter Reset using Wic Reset Connect.

Warenkorb