Fix Epson TX400 Service Required – Waste Counter Reset

Epson TX400 Waste Ink Counter Reset

When the Epson TX400 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX400 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson TX400 Stops Printing (Waste Counter Limit)

Most Epson TX400 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson TX400 Waste Ink Counter in 3 Steps

  1. Trin 1: Prepare a Windows PC + USB cable and connect Epson TX400 directly. Keep Internet enabled for validation.
  2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX400 appears in the device list.
  3. Trin 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX400.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruktioner

Most Epson TX400 waste counter resets finish in ~1–2 minutes.

FAQ

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson TX400 – Waste Ink Counter Reset using Wic Reset Connect.

Indkøbskurv