Epson EP-705A Waste Ink Counter Reset

When the Epson EP-705A reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson EP-705A uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson EP-705A Stops Printing (Waste Counter Limit)

Et servicebesøg er ofte unødvendigt. Wic Reset Connect allows a safe Epson EP-705A waste counter reset in minutes.

Hvordan fejlen opstår

• ‘Service påkrævet’/meddelelse om levetid i driver eller hjælpeprogram
• Vedligeholdelses-/supportkode (varierer efter model/driver)
• Udskrivning stopper efter rengøringscyklusser
• Advarslen gentages efter genstart af printeren

Reset Epson EP-705A Waste Ink Counter in 3 Steps

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson EP-705A directly. Keep Internet enabled for validation.
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson EP-705A appears in the device list.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson EP-705A.

Most Epson EP-705A waste counter resets finish in ~1–2 minutes.

Før du begynder

• Windows 7/8/10/11 PC
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Stabil internetforbindelse under nulstilling