Epson CX4000 Waste Ink Counter Reset

When the Epson CX4000 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson CX4000 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson CX4000 Show ‘Service Required’?

Most Epson CX4000 waste ink counter locks are solved by a software counter reset. Wic Reset Connect giver en ligetil procedure.

Typiske tegn

• Printeren nægter at udskrive, selv om der er blæk til rådighed
• Epson Status Monitor viser advarsel om vedligeholdelse
• Blinkende lys og blokerede jobs
• Enheden er låst, indtil nulstilling er udført

Reset Epson CX4000 Waste Ink Counter in 3 Steps

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson CX4000 via USB (Wi-Fi reset is not supported).
2. Trin 2: Løb Wic Reset Connect as Administrator and confirm Epson CX4000 is detected.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson CX4000 to finalize.

Most Epson CX4000 waste counter resets finish in ~1–2 minutes.

Hvad du har brug for

• Stabil internetforbindelse under nulstilling
• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• Windows 7/8/10/11 PC

Fejlfinding

• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Genstart printeren og pc'en, og prøv igen.
• Luk Epson Status Monitor eller andre printerværktøjer.
• Brug en direkte USB-forbindelse (undgå hubs).

Ofte stillede spørgsmål