Model-specific reset guide
Canon MG5550 Ink Absorber Full Reset
Canon MG5550 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
The waste ink counter inside Canon MG5550
Canon MG5550 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5550. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5550
- Turn the printer off.
- Stiskněte a podržte tlačítko Zastavení/resetování.
- Stiskněte a podržte tlačítko Stop/Reset. Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5550
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5550 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5550 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Connect Canon MG5550 directly to the computer and try another data-capable USB cable or port.
Canon MG5550 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon MG5550 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG5550
Ready to reset Canon MG5550? Verify the power light, USB connection and service-mode state before continuing.