特定型号重置指南
Epson Photo 1410 重置废墨计数器
A waste ink counter warning can prevent Epson Photo 1410 from printing even when the printer is otherwise working normally. Follow the checks and reset sequence below to restore operation safely.
Why the ink pad counter blocks Epson Photo 1410
Epson Photo 1410 uses stored counter data to estimate absorber usage. The estimate may reach its limit before the pads appear completely saturated, but physical maintenance should still be considered.
Wic Reset Connect 旨在重置兼容的计数器 Epson Photo 1410. 。必要时仍应检查并维护实体废墨系统。.
Reset the counter in Epson Photo 1410
重置通常只需几分钟，但在使用密钥之前，必须正确检测到打印机。.
-
安装原始驱动程序
Install the official Epson driver for Photo 1410 and confirm that Windows can see the printer.
-
通过 USB 直接连接
Connect Epson Photo 1410 to the computer without Wi-Fi, a hub or an adapter.
-
启动 Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson Photo 1410.
-
输入密钥并重置
输入已购买的密钥，选择“重置”，并保持打印机连接状态，直到操作完成。.
If Epson Photo 1410 is not detected
- Install the original Epson driver for Photo 1410; a generic Windows driver may not expose the required communication interface.
- 如果未检测到打印机，请尝试其他 USB 端口和已知支持数据传输的 USB 线缆。.
- 清除暂停的打印任务；如果其他程序占用了 USB 连接，请同时重新启动打印机和 Windows。.
- 以管理员身份运行 Wic Reset Connect，并在整个验证过程中保持互联网连接处于活动状态。.
Epson Photo 1410 reset FAQ
重置会清洁或更换墨垫吗？
不会。它会更改存储的计数器值。当实体废墨系统的状况需要时，请对其进行检查、清洁或更换。.
重置需要多长时间？
打印机被正确检测到后，重置本身通常会在约 1–2 分钟内完成。.
Does Epson Photo 1410 need service mode?
不需要。Epson 打印机不使用 Canon 服务模式操作顺序。通过 USB 正常连接打印机即可。.