特定型号重置指南
Epson ET-2403 Reset Waste Ink Counter
The service-required message on Epson ET-2403 often relates to the internal waste ink counter rather than an empty cartridge or paper fault. The steps below help you confirm and resolve that condition.
The counter behind the Epson ET-2403 warning
During head cleaning and normal maintenance, unused ink is directed into internal absorber pads. Epson ET-2403 estimates that accumulation with a software counter; it does not directly measure the physical amount of ink in the pads.
Wic Reset Connect 旨在重置兼容的计数器 Epson ET-2403. 。必要时仍应检查并维护实体废墨系统。.
Reset the counter in Epson ET-2403
先完成以下连接检查，然后运行重置程序；在此过程中不要打开其他打印机程序。.
-
安装原始驱动程序
Install the official Epson driver for ET-2403 and confirm that Windows can see the printer.
-
通过 USB 直接连接
Connect Epson ET-2403 to the computer without Wi-Fi, a hub or an adapter.
-
启动 Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson ET-2403.
-
输入密钥并重置
输入已购买的密钥，选择“重置”，并保持打印机连接状态，直到操作完成。.
If Epson ET-2403 is not detected
- 开始前，请关闭 Epson 状态监视器以及任何其他 Epson 维护软件，以便进行 Wic Reset Connect。.
- 如果未检测到打印机，请尝试其他 USB 端口和已知支持数据传输的 USB 线缆。.
- 清除暂停的打印任务；如果其他程序占用了 USB 连接，请同时重新启动打印机和 Windows。.
- Install the original Epson driver for ET-2403; a generic Windows driver may not expose the required communication interface.
Epson ET-2403 reset FAQ
重置需要多长时间？
打印机被正确检测到后，重置本身通常会在约 1–2 分钟内完成。.
如果第一次重置尝试失败怎么办？
请先解决驱动程序或 USB 通信问题。如果密钥已被使用，请使用新密钥生成器或联系支持人员。.
Does Epson ET-2403 need service mode?
不需要。Epson 打印机不使用 Canon 服务模式操作顺序。通过 USB 正常连接打印机即可。.