Canon MG6850 Ink Absorber Full Reset

Canon MG6850 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MG6850 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MG6850. Service mode instructions are shown only when a matching series procedure is known.

常见症状

• ‘墨水吸收器已满’/‘需要维修 ’信息
• 支持/服务代码（因系列而异）
• 清洁循环后打印受阻
• 需要重置才能继续打印

How to Enter Service Mode on Canon MG6850

If your Canon MG6850 supports service mode reset, follow the steps below before performing the counter reset.

1. 打开打印机 关闭.
2. 按住 停止/重置.
3. 在按住停止/复位的同时，按住 电源.
4. 发布 停止/重置 (继续保持动力）。.
5. 新闻 停止/重置 6次.
6. 发布 电源 - 打印机应进入服务模式。.

如果不起作用，请仔细重复上述步骤。按压次数取决于系列。.

执行废墨计数器重置

Once the counter is cleared, Canon MG6850 should exit the locked state and printing should resume normally.

继续之前

重置计数器不会对吸收垫进行物理清洁。对于重度使用的情况，吸收垫最终可能需要清洁或更换。.

重置工具和说明

如果您的机型没有显示维修模式部分，则表示没有找到与其系列匹配的程序。.