特定型号重置指南
Canon MG5610 Ink Absorber Full Reset
If Canon MG5610 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
Understanding the Canon MG5610 ink absorber warning
The lock is based on accumulated maintenance activity. Resetting Canon MG5610 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect 旨在重置兼容的计数器 Canon MG5610. 。必要时仍应检查并维护实体废墨系统。.
How to enter service mode on Canon MG5610
- 关闭打印机。.
- 按住 停止/重置.
- 在按住停止/复位的同时，按住 电源.
- 松开 Stop/Reset，但继续按住 Power。.
- 按下并松开 Stop/Reset 6次.
- 稍等片刻，然后松开 Power。电源指示灯应保持稳定亮起。.
Reset the counter in Canon MG5610
The counter reset normally takes only a few minutes after Canon MG5610 has entered service mode successfully.
-
准备打印机
解决其他错误，确认电源指示灯稳定亮起，然后使用上述顺序进入维修模式。.
-
通过 USB 直接连接
Connect Canon MG5610 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
启动 Wic Reset Connect
以管理员身份运行程序，并等待检测到处于 Canon 维修模式的设备。.
-
输入密钥并重置
输入购买的密钥，选择 Reset，并保持打印机连接，直到出现确认信息。.
If Canon MG5610 is not detected
- 关闭 Canon 维护工具，并清除已暂停的打印作业，然后再打开 Wic Reset Connect。.
- 如果电源指示灯闪烁，请先解决显示的墨盒、纸张或机械错误，然后再尝试进入维修模式。.
- Connect Canon MG5610 directly to the computer and try another data-capable USB cable or port.
- 以管理员身份运行 Wic Reset Connect，并保持互联网访问处于启用状态，以便验证密钥。.
Canon MG5610 reset FAQ
Does Canon MG5610 require service mode?
是。打印机必须先公开其维护接口，才能使用 Wic Reset Connect 重置计数器。.
重置会清洁吸墨垫吗？
不会。它只会重置存储的计数器。当吸墨垫的实际状况需要维护时，请检查、清洁或更换吸墨垫。.
应该按多少次停止/复位键？
For Canon MG5610, use 6 Stop/Reset presses in the sequence shown on this page.