Model-specific reset guide
Đặt lại bộ đếm mực thải trên máy in Epson L4261
A waste ink counter warning can prevent Epson L4261 from printing even when the printer is otherwise working normally. Follow the checks and reset sequence below to restore operation safely.
The counter behind the Epson L4261 warning
Epson L4261 uses stored counter data to estimate absorber usage. The estimate may reach its limit before the pads appear completely saturated, but physical maintenance should still be considered.
Wic Reset Connect is designed to reset the compatible counter in Epson L4261. The physical waste ink system should still be inspected and maintained when necessary.
Reset the counter in Epson L4261
Correct preparation protects the reset key from being used during a failed communication attempt. Verify each requirement before selecting Reset.
-
Install the original driver
Install the official Epson driver for L4261 and confirm that Windows can see the printer.
-
Connect directly by USB
Connect Epson L4261 to the computer without Wi-Fi, a hub or an adapter.
-
Start Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson L4261.
-
Enter the key and reset
Enter the purchased key, choose Reset and keep the printer connected until completion.
If Epson L4261 is not detected
- Run Wic Reset Connect as Administrator and keep the internet connection active throughout validation.
- Install the original Epson driver for L4261; a generic Windows driver may not expose the required communication interface.
- Close Epson Status Monitor and any other Epson maintenance software before starting Wic Reset Connect.
- Clear paused print jobs and restart both the printer and Windows if another program is holding the USB connection.
Epson L4261 reset FAQ
What if the first reset attempt fails?
Correct the driver or USB communication problem first. If the key was consumed, use the new-key generator or contact support.
Can I reset Epson L4261 over Wi-Fi?
No. Wic Reset Connect requires a direct USB connection to the Windows computer.
How long does the reset take?
The reset itself usually finishes in about 1–2 minutes after the printer has been detected correctly.
Restore Epson L4261
Ready to restore Epson L4261? Check the requirements once more and start the guided reset.