Model-specific reset guide
Canon TS3420 Ink Absorber Full Reset
An absorber warning on Canon TS3420 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
Before resetting Canon TS3420
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS3420. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS3420
- Turn the printer off.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 lần.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS3420
Prepare Canon TS3420 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS3420 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS3420 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon TS3420 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TS3420 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Tôi nên nhấn nút Stop/Reset bao nhiêu lần?
For Canon TS3420, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS3420
Prepare Canon TS3420, enter service mode and complete the reset with a valid Wic Reset Connect key.