Model-specific reset guide
Canon MP270 Ink Absorber Full Reset
When Canon MP270 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What stops Canon MP270 from printing
Cleaning operations send unused ink into absorber pads inside the printer. Canon MP270 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon MP270. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MP270
- Turn the printer off.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 2 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MP270
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MP270 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MP270 is not detected
- Connect Canon MP270 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MP270 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Tôi nên nhấn nút Stop/Reset bao nhiêu lần?
For Canon MP270, use 2 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon MP270
Wic Reset Connect combines a guided reset with support if Canon MP270 does not respond as expected.