Model-specific reset guide
Canon MG7765 Ink Absorber Full Reset
When Canon MG7765 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
Understanding the Canon MG7765 ink absorber warning
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG7765. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG7765
- Turn the printer off.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 lần.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG7765
The counter reset normally takes only a few minutes after Canon MG7765 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG7765 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG7765 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon MG7765 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon MG7765 reset FAQ
Tôi nên nhấn nút Stop/Reset bao nhiêu lần?
For Canon MG7765, use 6 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon MG7765 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG7765
Use the correct sequence for Canon MG7765 and restore printing without an unnecessary service visit.