Model-specific reset guide
Canon G6091 Ink Absorber Full Reset
Canon G6091 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon G6091 reports an absorber error
Cleaning operations send unused ink into absorber pads inside the printer. Canon G6091 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon G6091. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G6091
- Turn the printer off.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 lần.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G6091
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G6091 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G6091 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon G6091 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon G6091 reset FAQ
Tôi nên nhấn nút Stop/Reset bao nhiêu lần?
For Canon G6091, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon G6091 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon G6091
Complete the Canon G6091 absorber counter reset in a few carefully prepared steps.