Model-specific reset guide
Canon G3410 Ink Absorber Full Reset
If Canon G3410 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
The waste ink counter inside Canon G3410
Cleaning operations send unused ink into absorber pads inside the printer. Canon G3410 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon G3410. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G3410
- Turn the printer off.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 lần.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G3410
Prepare Canon G3410 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G3410 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G3410 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon G3410 reset FAQ
Tôi nên nhấn nút Stop/Reset bao nhiêu lần?
For Canon G3410, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon G3410 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon G3410
Wic Reset Connect combines a guided reset with support if Canon G3410 does not respond as expected.