Epson XP-710 Waste Ink Counter Reset

If your Epson XP-710 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-710 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-710 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-710 waste counter reset in minutes.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Step-by-Step: Epson XP-710 Waste Counter Reset

1. Крок 1: Prepare a Windows PC + USB cable and connect Epson XP-710 directly. Keep Internet enabled for validation.
2. Крок 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-710 appears in the device list.
3. Крок 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-710.

Most Epson XP-710 waste counter resets finish in ~1–2 minutes.

What You Need

• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions