Model-specific reset guide
Canon MG5560 Ink Absorber Full Reset
Canon MG5560 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon MG5560
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5560. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5560
- Turn the printer off.
- Tryck och håll in Stopp/återställning.
- Medan du håller Stop/Reset, tryck och håll in Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 gånger.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5560
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5560 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5560 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon MG5560 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Hur många gånger ska jag trycka på Stop/Reset?
For Canon MG5560, use 6 Stop/Reset presses in the sequence shown on this page.
Restore Canon MG5560
Follow the verified steps for Canon MG5560, then restart the printer and return to normal operation.