Fix Epson XP-434 Service Required – Waste Counter Reset

Epson XP-434 Waste Ink Counter Reset

If your Epson XP-434 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-434 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson XP-434 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-434 waste counter reset in minutes.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson XP-434 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson XP-434 directly. Keep Internet enabled for validation.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-434 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-434 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson XP-434 waste counter resets finish in ~1–2 minutes.

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson XP-434 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа