Epson TX101 Waste Ink Counter Reset

The Epson TX101 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX101 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson TX101 Show ‘Service Required’?

Most Epson TX101 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson TX101 Waste Ink Counter in 3 Steps

1. Step 1: Connect Epson TX101 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX101 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX101.

Most Epson TX101 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.

Frequently Asked Questions