Epson R310 Waste Ink Counter Reset

The Epson R310 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R310 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson R310 Ink Pad Counter Warning?

Most Epson R310 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Three Steps to Restore Epson R310 Printing

1. Step 1: Prepare a Windows PC + USB cable and connect Epson R310 directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson R310 appears in the device list.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson R310.

Most Epson R310 waste counter resets finish in ~1–2 minutes.

What You Need

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Restart printer and PC, then try again.

Frequently Asked Questions