Reset Epson L5290 Waste Ink Counter in Minutes

Epson L5290 Waste Ink Counter Reset

When the Epson L5290 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L5290 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson L5290 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson L5290 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson L5290 Waste Counter Reset

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson L5290 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson L5290 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson L5290 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson L5290 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson L5290 – Waste Ink Counter Reset using Wic Reset Connect.

Корпа