Epson WorkForce 520 Waste Ink Counter Reset

The Epson WorkForce 520 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WorkForce 520 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson WorkForce 520 Waste Ink Counter

Most Epson WorkForce 520 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Step-by-Step: Epson WorkForce 520 Waste Counter Reset

1. 1. korak: Prepare a Windows PC + USB cable and connect Epson WorkForce 520 directly. Keep Internet enabled for validation.
2. 2. korak: Run Wic Reset Connect as Administrator and confirm Epson WorkForce 520 is detected.
3. 3. korak: Use the key to reset the counter, wait for completion, then restart Epson WorkForce 520 to finalize.

Most Epson WorkForce 520 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.