Epson WorkForce 320 Ink Pad Counter Reset Guide

Epson WorkForce 320 Waste Ink Counter Reset

When the Epson WorkForce 320 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson WorkForce 320 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson WorkForce 320 Stops Printing (Waste Counter Limit)

Most Epson WorkForce 320 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson WorkForce 320 Waste Ink Counter in 3 Steps

  1. 1. korak: Prepare a Windows PC + USB cable and connect Epson WorkForce 320 directly. Keep Internet enabled for validation.
  2. 2. korak: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WorkForce 320.
  3. 3. korak: Paste the reset key, click Reset, and after completion power-cycle Epson WorkForce 320.
Buy Reset Key ⬇️ Download Wic Reset Connect Navodila

Most Epson WorkForce 320 waste counter resets finish in ~1–2 minutes.

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson WorkForce 320 – Waste Ink Counter Reset using Wic Reset Connect.

Nakupovalna košarica