Model-specific reset guide
Canon TS701 Ink Absorber Full Reset
Canon TS701 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
The waste ink counter inside Canon TS701
Cleaning operations send unused ink into absorber pads inside the printer. Canon TS701 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon TS701. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS701
- Turn the printer off.
- Pritisnite in pridržite Ustavitev/ponastavitev.
- Medtem ko držite Stop/Reset, pritisnite in držite Napajanje.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5-krat.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS701
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS701 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS701 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon TS701 directly to the computer and try another data-capable USB cable or port.
Canon TS701 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon TS701 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon TS701
Complete the Canon TS701 absorber counter reset in a few carefully prepared steps.