Epson TX112 Waste Ink Counter Reset
If your Epson TX112 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.
A waste ink counter in the Epson TX112 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.
What Causes the Epson TX112 Ink Pad Counter Warning?
Most Epson TX112 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.
Common Symptoms
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Reset Epson TX112 Waste Ink Counter in 3 Steps
- Krok 1: Connect Epson TX112 to a Windows computer with a stable Internet connection using a USB cable.
- Krok 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX112 appears in the device list.
- Krok 3: Use the key to reset the counter, wait for completion, then restart Epson TX112 to finalize.
Most Epson TX112 waste counter resets finish in ~1–2 minutes.
What You Need
- Stable Internet connection during reset
- Windows 7/8/10/11 PC
- USB connection required (Wi-Fi reset not supported)
- Valid Wic Reset Connect reset key
Troubleshooting
- Run the app as Administrator.
- Restart printer and PC, then try again.
- Temporarily disable VPN/proxy if validation fails.
- Close Epson Status Monitor or other printer utilities.
- Use a direct USB connection (avoid hubs).
FAQ
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Guide prepared for Epson TX112 – Waste Ink Counter Reset using Wic Reset Connect.