Epson ET-2704 Ink Pad Counter Reset Guide

Epson ET-2704 Waste Ink Counter Reset

The Epson ET-2704 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson ET-2704 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson ET-2704 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson ET-2704 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson ET-2704 Printing

  1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2704 via USB (Wi-Fi reset is not supported).
  2. Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2704.
  3. Krok 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2704 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Pokyny

Most Epson ET-2704 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ET-2704 – Waste Ink Counter Reset using Wic Reset Connect.

Nákupný košík