Epson BX320FW Waste Ink Counter Reset

Epson BX320FW Waste Ink Counter Reset

When the Epson BX320FW reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson BX320FW accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson BX320FW Waste Ink Counter

With Wic Reset Connect, you can reset the Epson BX320FW waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson BX320FW Printing

  1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson BX320FW via USB (Wi-Fi reset is not supported).
  2. Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson BX320FW.
  3. Krok 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson BX320FW.
Buy Reset Key ⬇️ Download Wic Reset Connect Pokyny

Most Epson BX320FW waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

  • Restart printer and PC, then try again.
  • Try another USB cable (some cables are charge-only).
  • Temporarily disable VPN/proxy if validation fails.
  • Run the app as Administrator.
  • Use a direct USB connection (avoid hubs).

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson BX320FW – Waste Ink Counter Reset using Wic Reset Connect.

Nákupný košík