Epson ME-401 Waste Ink Counter Reset

When the Epson ME-401 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-401 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson ME-401 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson ME-401 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Step-by-Step: Epson ME-401 Waste Counter Reset

1. Pasul 1: Connect Epson ME-401 to a Windows computer with a stable Internet connection using a USB cable.
2. Pasul 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ME-401.
3. Pasul 3: Use the key to reset the counter, wait for completion, then restart Epson ME-401 to finalize.

Most Epson ME-401 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC

Troubleshooting

• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).

FAQ