Model-specific reset guide
Canon MB5410 Ink Absorber Full Reset
Canon MB5410 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What the Canon MB5410 service message means
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon MB5410 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon MB5410. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MB5410
- Turn the printer off.
- Apăsați și mențineți apăsat Oprire/Resetare.
- În timp ce țineți apăsat Stop/Reset, apăsați și țineți apăsat Putere.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset de 5 ori.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MB5410
Service mode must be entered correctly before Wic Reset Connect can communicate with the maintenance interface. Resolve other printer errors first.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MB5410 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MB5410 is not detected
- Connect Canon MB5410 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon MB5410 reset FAQ
De câte ori trebuie să apăs pe Stop/Reset?
For Canon MB5410, use 5 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon MB5410
Wic Reset Connect combines a guided reset with support if Canon MB5410 does not respond as expected.