Model-specific reset guide
Canon MB2100 Ink Absorber Full Reset
Canon MB2100 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What the Canon MB2100 service message means
Canon MB2100 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MB2100. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MB2100
- Turn the printer off.
- Apăsați și mențineți apăsat Oprire/Resetare.
- În timp ce țineți apăsat Stop/Reset, apăsați și țineți apăsat Putere.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset de 5 ori.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MB2100
The counter reset normally takes only a few minutes after Canon MB2100 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MB2100 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MB2100 is not detected
- Connect Canon MB2100 directly to the computer and try another data-capable USB cable or port.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon MB2100 reset FAQ
Does Canon MB2100 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon MB2100
Ready to reset Canon MB2100? Verify the power light, USB connection and service-mode state before continuing.