Epson TX121 Waste Ink Counter Reset

When the Epson TX121 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson TX121 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson TX121 Show ‘Service Required’?

Most Epson TX121 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Three Steps to Restore Epson TX121 Printing

1. Passo 1: Connect Epson TX121 to a Windows computer with a stable Internet connection using a USB cable.
2. Passo 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX121 appears in the device list.
3. Etapa 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX121.

Most Epson TX121 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.