How to Reset Epson L3210 Waste Ink Counter

Epson L3210 Waste Ink Counter Reset

When the Epson L3210 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L3210 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson L3210 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L3210 waste counter reset in minutes.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson L3210 Ink Pad Counter Reset – Quick Steps

  1. Passo 1: Connect Epson L3210 to a Windows computer with a stable Internet connection using a USB cable.
  2. Passo 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L3210.
  3. Etapa 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L3210.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruções

Most Epson L3210 waste counter resets finish in ~1–2 minutes.

What You Need

  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)

Frequently Asked Questions

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson L3210 – Waste Ink Counter Reset using Wic Reset Connect.

Carrinho de compras