Epson Artisan 810 Waste Ink Counter Reset

The Epson Artisan 810 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson Artisan 810 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson Artisan 810 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson Artisan 810 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson Artisan 810 Waste Counter Reset

1. Passo 1: Connect Epson Artisan 810 to a Windows computer with a stable Internet connection using a USB cable.
2. Passo 2: Run Wic Reset Connect as Administrator and confirm Epson Artisan 810 is detected.
3. Etapa 3: Use the key to reset the counter, wait for completion, then restart Epson Artisan 810 to finalize.

Most Epson Artisan 810 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset

Troubleshooting

• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.