Reset Epson T33 Waste Ink Counter in Minutes

Epson T33 Waste Ink Counter Reset

When the Epson T33 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson T33 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson T33 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson T33 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Reset Epson T33 Waste Ink Counter in 3 Steps

  1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson T33 via USB (Wi-Fi reset is not supported).
  2. Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson T33.
  3. Krok 3: Use the key to reset the counter, wait for completion, then restart Epson T33 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instrukcje

Most Epson T33 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC

If the Printer Is Not Detected

  • Try another USB cable (some cables are charge-only).
  • Restart printer and PC, then try again.
  • Temporarily disable VPN/proxy if validation fails.
  • Close Epson Status Monitor or other printer utilities.
  • Run the app as Administrator.

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson T33 – Waste Ink Counter Reset using Wic Reset Connect.

Koszyk