Epson T1110 Waste Ink Counter Reset

Epson T1110 Waste Ink Counter Reset

When the Epson T1110 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson T1110 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson T1110 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson T1110 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Step-by-Step: Epson T1110 Waste Counter Reset

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson T1110 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson T1110 is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson T1110.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson T1110 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC

Troubleshooting

  • Use a direct USB connection (avoid hubs).
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.
  • Close Epson Status Monitor or other printer utilities.
  • Restart printer and PC, then try again.

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson T1110 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart