Epson NX200 Waste Ink Counter Reset

If your Epson NX200 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson NX200 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson NX200 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson NX200 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson NX200 Printing

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson NX200 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson NX200 appears in the device list.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson NX200 to finalize.

Most Epson NX200 waste counter resets finish in ~1–2 minutes.

System Requirements

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions