Canon TR150 Ink Absorber Full Reset

When Canon TR150 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon TR150. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TR150

To access maintenance functions, Canon TR150 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.
• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.

Frequently Asked Questions