MP630 Printer Reset – Ink Absorber Counter Explained

Canon MP630 Ink Absorber Full Reset

Canon MP630 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MP630. Service mode instructions are shown only when a matching series procedure is known.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ

How long does it take?

Usually a few minutes once the correct steps are followed.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MP630 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.