Model-specific reset guide
Canon MP630 Ink Absorber Full Reset
Canon MP630 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What stops Canon MP630 from printing
Cleaning operations send unused ink into absorber pads inside the printer. Canon MP630 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon MP630. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MP630
- Turn the printer off.
- Stiskněte a podržte tlačítko Zastavení/resetování.
- Stiskněte a podržte tlačítko Stop/Reset. Power.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 2krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MP630
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MP630 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MP630 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon MP630 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Kolikrát mám stisknout tlačítko Stop/Reset?
For Canon MP630, use 2 Stop/Reset presses in the sequence shown on this page.
Restore Canon MP630
Wic Reset Connect combines a guided reset with support if Canon MP630 does not respond as expected.