Canon MG7500 Ink Absorber Full Reset

Canon MG7500 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MG7500 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MG7500. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon MG7500

To access maintenance functions, Canon MG7500 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Use a reliable USB connection and follow the steps in order.

Common Fixes

• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Try a different USB cable/port if using PC software.

FAQ