Canon MG7100 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MG7100 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MG7100. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon MG7100

If your Canon MG7100 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

• Power-cycle the printer and try again.
• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions