Model-specific reset guide
Canon MG7100 Ink Absorber Full Reset
Canon MG7100 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What the Canon MG7100 service message means
Canon MG7100 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MG7100. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG7100
- Turn the printer off.
- Basın ve basılı tutun Durdur/Sıfırla.
- Stop/Reset düğmesini basılı tutarken Güç.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 kez.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG7100
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG7100 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG7100 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon MG7100 directly to the computer and try another data-capable USB cable or port.
Canon MG7100 reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Stop/Reset düğmesine kaç kez basmalıyım?
For Canon MG7100, use 6 Stop/Reset presses in the sequence shown on this page.
Restore Canon MG7100
Prepare Canon MG7100, enter service mode and complete the reset with a valid Wic Reset Connect key.