How to Reset Ink Absorber on Canon MG6730

Canon MG6730 Ink Absorber Full Reset

Canon MG6730 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MG6730 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MG6730. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon MG6730

Some Canon series require entering service mode before the ink absorber counter can be reset.

Turn the printer OFF.
Press and hold Stop/Reset.
While holding Stop/Reset, press and hold Power.
Release Stop/Reset (keep holding Power).
Press Stop/Reset 6 times.
Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

Once the counter is cleared, Canon MG6730 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Frequently Asked Questions

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon MG6730 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.