How to Reset Ink Absorber on Canon MB5370

Canon MB5370 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MB5370 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MB5370. Service mode instructions are shown only when a matching series procedure is known.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Frequently Asked Questions

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How long does it take?

Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MB5370 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.