Canon G7000 Ink Absorber Full Reset

Canon G7000 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon G7000. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon G7000

If your Canon G7000 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon G7000 should exit the locked state and printing should resume normally.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

• Try a different USB cable/port if using PC software.
• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).

FAQ